C82 防火技术 标准查询与下载

ANSI/UL 300a-2013 商用烹饪设备防护用消防系统火灾试验的安全标准

Standard for Safety for Fire Testing of Fire Extinguishing Systems for Protection of Commercial Cooking Equipment

ANSI/NFPA 1005-2013 陆地消防队员海上防火的职业资格标准

Standard for Professional Qualifications for Marine Fire Fighting for Land-Based Fire Fighters

ANSI/UL 300-2013 商用烹饪设备保护用消防系统火灾试验的安全性标准

Standard for Safety for Fire Testing of Fire Extinguishing Systems for Protection of Commercial Cooking Equipment

ANSI/NFPA 1720-2013 志愿消防部门对公众进行的消防行动,紧急医疗事故处理和特别行动组织和部署标准

Standard for the Organization and Deployment of Fire Suppression Operations, Emergency Medical Operations and Special Operations to the Public by Volunteer Fire Departments

ANSI/NFPA 1143-2013 荒地消防管理标准

Standard for Wildland Fire Management

BS EN 1365-1:2012 承重构件的耐火试验.墙

Fire resistance tests for loadbearing elements. Walls

BS 5908-2:2012 在经营场所处理易燃气体、液体和粉尘的火灾和爆炸预防措施.适用标准和法规的指南

This part of BS 5908 gives guidance on the legislation and standards applicable to onshore industrial premises that handle significant quantities of flammable gases, liquids or dusts.It identifies the different strands of legislation that apply to those who supply,transport, store,or use such materials, and those who supply plant and equipment for any of these activities,and provides a guide to relevant standards so that suppliers and users of products that create fire and explosion hazards can identify which might be relevant to their activities. This part of BS 5908 does not cover offshore oil and gas production or coal or other mining activities,and only references legislation and standards relevant to the distribution and supply of natural gas where these are also relevant to other activities.

Fire and explosion precautions at premises handling flammable gases, liquids and dusts. Guide to applicable standards and regulations

DB34/T 1788-2012 公路隧道防火涂料喷涂施工及验收规程

为了规范隧道防火涂料的喷涂施工和验收，保证施工质量，确保隧道防火安全性，制定本规程。 本规程适用于各种新建、扩建、改建公路隧道混凝土结构工程的防火涂料喷涂施工和验收。 隧道防火涂料喷涂施工和验收，除符合本规程外，尚应符合国家现行有关标准、规范的规定。

Regulations for Spraying Construction and Acceptance of Fireproof Coatings for Highway Tunnels

ISO 16737:2012 消防安全工程.控制代数方程的要求.排气流量

Fire safety engineering - Requirements governing algebraic equations - Vent flows

GA 533-2012 挡烟垂壁

本标准规定了挡烟垂壁的术语和定义、分类、要求、试验方法、检验规则以及标志、包装、运输和贮存。 本标准适用于工业与民用建筑中设置防烟分区所使用的挡烟垂壁。

Smoke barriers

BS EN 1363-1:2012 耐火试验.通用要求

Fire resistance tests. General requirements

ISO 7240-10:2012 火灾探测和警报系统. 第10部分: 点型火焰探测器

This part of ISO 7240 specifies requirements, test methods and performance criteria for point-type, resettable flame detectors that operate using radiation from a flame for use in fire detection systems installed in buildings. This part of ISO 7240 is not applicable to flame detectors with special characteristics, developed for specific risks. It can be used as guidance in assessing other types of flame detectors not included in this part of ISO 7240. The performance of flame detectors is assessed from results obtained in specific tests. This part of ISO 7240 is not intended to place any other restrictions on the design and construction of such flame detectors.

Fire detection and alarm systems - Part 10: Point-type flame detectors

BS ISO 19706:2011 评估火灾对人造成危害的指南

Guidelines for assessing the fire threat to people

DIN EN 15882-1:2012 服务设备的耐火试验的结果的扩展应用.第1部分:导管.德文版本 EN 15882-1-2011

Extended application of results from fire resistance tests for service installations - Part 1: Ducts; German version EN 15882-1:2011

ASTM E1388-12 从火烧瓦砾样品中进行液上蒸气取样的标准操作规程

This procedure is particularly useful for screening fire debris samples to determine relative ignitable liquid concentrations and possible ignitable liquid class prior to extraction with other techniques. This practice is useful when volatile oxygenated products such as alcohols or lacquer thinners are suspected. This practice is the least sensitive of the sample preparation techniques and may not detect quantities of less than 10 μL of an ignitable liquid. Because this separation takes place in a closed container, the sample remains in approximately the same condition in which it was submitted. Repeat and interlaboratory analyses are therefore possible. Due to variables in the debris sample condition prior to headspace sampling, complete reproducibility of chromatograms may be difficult to obtain. To obtain greater reproducibility, use one of the separation procedures which results in a solution of the ignitable liquid residue (see Practices E1386, E1412, and E1413). To obtain greater sensitivity for petroleum distillates and oxygenated products, use solid phase microextraction. (See Practice E2154.) High concentrations of highly volatile compounds may swamp the headspace, inhibiting the recovery of less volatile components.1.1 This practice describes the procedure for removing small quantities of ignitable liquid vapor from samples of fire debris by sampling the headspace of the debris container. 1.2 Separation and concentration procedures are listed in the referenced documents. (See Practices E1386, E1412, E1413, and E2154.) 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Sampling of Headspace Vapors from Fire Debris Samples

ANSI/NFPA 654-2012 可燃性固体颗粒的生产、加工和搬运中防火和防尘爆标准

1.1.1* This standard shall apply to all phases of the manufacture, processing, blending, pneumatic conveying, repackaging, and handling of combustible particulate solids or hybrid mixtures, regardless of concentration or particle size, where the materials present a fire or explosion hazard. 1.1.2 This standard shall apply to systems that convey combustible particulate solids that are produced as a result of a principal or incidental activity, regardless of concentration or particle size, where the materials present a fire or explosion hazard. 1.1.3 This standard shall not apply to materials covered by the following documents, unless specifically referenced by the applicable document: (1) NFPA 30B, Code for the Manufacture and Storage of Aerosol Products (2) NFPA 61, Standard for the Prevention of Fires and Dust Explosions in Agricultural and Food Products Facilities (3) NFPA 120, Standard for Coal Preparation Plants (4) NFPA 432, Code for the Storage of Organic Peroxide Formulations (5) NFPA 480, Standard for the Storage, Handling, and Processing of Magnesium Solids and Powders (6) NFPA 481, Standard for the Production, Processing, Handling, and Storage of Titanium (7) NFPA 482, Standard for the Production, Processing, Handling, and Storage of Zirconium (8) NFPA 485, Standard for the Storage, Handling, Processing, and Use of Lithium Metal (9) NFPA 495, Explosive Materials Code (10) NFPA 651, Standard for the Machining and Finishing of Aluminum and the Production and Handling of Aluminum Powders (11) NFPA 655, Standard for Prevention of Sulfur Fires and Explosions (12) NFPA 664, Standard for the Prevention of Fires and Explosions in Wood Processing and Woodworking Facilities (13) NFPA 1124, Code for the Manufacture, Transportation, and Storage of Fireworks and Pyrotechnic Articles (14) NFPA 1125, Code for the Manufacture of Model Rocket and High Power Rocket Motors (15) NFPA 8503, Standard for Pulverized Fuel Systems 1.1.4 In the event of a conflict between this standard and a specific occupancy standard, the specific occupancy standard requirements shall apply.

Standard for the Prevention of Fire and Dust Explosions from the Manufacturing, Processing, and Handling of Combustible Particulate Solids

ANSI/NFPA 204-2012 排烟和排热的标准

1.1 Scope. 1.1.1* This standard shall apply to the design of venting systems for the emergency venting of products of combustion from fires in buildings. The provisions of Chapters 4 through 10 shall apply to the design of venting systems for the emergency venting of products of combustion from fires in nonsprinklered, single-story buildings using both hand calculations and computer-based solution methods as provided in Chapter 9. Chapter 11 shall apply to venting in sprinklered buildings.

Standard for Smoke and Heat Venting

GA159-2011 水基型阻燃处理剂

Water-based fire retardants

GA 159-2011 水基型阻燃处理剂

本标准规定了水基型阻燃处理剂的术语和定义、分类、技术要求、试验程序、检验规则、标志、包装、贮存等。 本标准适用于水基型阻燃处理剂。

Water-based fire retardants

DB64/ 707-2011 住宅厨房卫生间防火型变压式排气道应用技术规程

Technical specification for application of fireproof variable pressure exhaust duct in residential kitchen and bathroom