P70 矿山、煤炭工程 标准查询与下载

MT/T 122-1985 GM系列菜煤机隔离开关

GM series vegetable coal machine isolating switch

ASTM E997-84(1992)e1 用破坏法测定均匀静载荷影响下外窗玻璃,隔墙和门的结构性能的标准试验方法

1.1 This test method is a procedure to determine if the probability of breakage of glass specimens tested is significantly greater than, signficantly less than, or not significantly different than the specified probability of breakage when exposed to a specified 60-s duration equivalent design load. It is not intended to be a design standard for determining the load resistance of glass. Practice E1300 shall be used for this purpose.1.2 This test method describes apparatus and procedures to select and apply a 60-s duration proof load to glass specimens, to determine the number of glass specimens to be tested, and to evaluate statistically the probability of breakage. This test method may be conducted using the standard test frame specified herein or a test frame of the user''s design.1.3 Proper use of this test method requires a knowledge of the principles of pressure measurement and an understanding of recommended glazing practices.1.4 The values stated in inch-pound units are to be regarded as standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7.

Standard Test Method for Structural Performance of Glass in Exterior Windows, Curtain Walls, and Doors Under the Influence of Uniform Static Loads by Destructive Methods

NF B51-227:1977 刨花板-动态冲切试验

Panneaux de particules - Essai de poinçonnement dynamique

MT 5021-1997 煤矿地面多绳摩擦式提升系统设计规范

Code for design of surface multi-rope friction hoisting system of coal mine

MT 5020-1996 露天煤矿施工组织设计规范

Code for design of organized construction of surface coal mine

MT 5019-1996 煤矿井下热害防治设计规范

Code for design of prevention and elimination of thermal disaster under the coal mine

MT 5018-1996 煤矿井释放瓦斯工程设计规范

Code of design of the gas drainage engineering of coal mine

MT/T 5022-1998 煤炭工业半地下储仓设计规范

Code for design of semi-underground storage bin in mine industry

MT/T 5016-1996 矿井通风安全装备标准

Standard for the equipment of ventilative safety of colliery

MT/T 5014-1995 煤炭工业给水排水设计规范

Code for design of water supply and sewerage engineering of coal industry

MT/T 5013-1995 煤炭工业采暖通风及供热设计规范

Code for design of heating,ventilation and heating of coal industry

MT/T 5012-1995 节能墙体EPS外保温工程质量检验评定标准

Standard for construction and acceptance of EPS out-insulation engineering of save energy wall

MT/T 5011-1995 节能墙体EPS外保温工程施工及验收规范

Code for construction and acceptance of EPS outinsulation engineering of save energy wall

MT/T 5010-1994 煤矿安装工程质量检验评定标准

Standard for quality inspection and assessment of installation engineering of coal mine

MT/T 5023-1998 选煤厂建筑结构设计规范

Code for design of buildings and structures of coal preparation plant

MT/T 5008-1994 煤炭工业矿区机电设备修理设施设计规范

Coal industry design code of repairing facilities for mechanical and electrical equipment of mine district

MT/T 5024-1999 煤矿矿井巷道断面及交叉点设计规范

Code for design of roadway section and junction of coal mine

MT 5006-1994 煤炭工业矿区总体设计规范

Code for the general design of coal mine area

MTJ 2-1980 煤矿地面窄轨铁路设计规范

Code for design of narrow-gauge railways in coal mines

MT/T 5025-1999 煤矿矿井斜井井筒及硐室设计规范

Code for design of inelined shaft and chambers of coal mine