BS 2000-313:2001
石油和石油产品的试验方法.BS 2000-313-2001液压油和润滑油的释气值测定

2003-01

石油和石油产品的试验方法.BS 2000-313-2001液压油和润滑油的释气值测定 是非强制性国家标准，您可以免费下载预览页

非常抱歉，我们暂时无法提供预览，您可以试试：免费下载 BS 2000-313:2001 前三页，或者稍后再访问。

如果您需要购买此标准的全文，请联系：。

注意：点击下载后，生成下载文件时间比较长，请耐心等待......

适用范围: This standard specifies a procedure for the determination of the measurement of the ability of turbine, gear and hydraulic oils to separate entrained air. It is applicable to both mineral and synthetic based products, but the current precision statement only applies to mineral oils. NOTE 1 - Agitation of lubricating and hydraulic oils with air in equipment such as bearings, couplings, gears, pumps and lines, can produce a dispersion of finely divided air bubbles in the oil. If the residence time in the reservoir is too short to allow the air bubbles to rise to the surface, a mixture of air and oil will circulate through the system. This may result in an inability to maintain oil pressure (particularly with centrifugal pumps), incomplete oil films in bearings and gears, and poor hydraulic system performance or failure. NOTE 2 - This standard measures the time for the entrained air content to fall to the relatively low value of 0,20 % [V/V] under a standardized set of test conditions, and hence permits the comparison of the ability of oils to separate entrained air under conditions where a separation time is available. Although the significance of the test results is not fully established, entrained air can cause sponginess and lack of sensitivity in the control of turbine and hydraulic systems. This standard may not be suitable for ranking oils in applications where residence times are short and gas contents are high.

BS 2000-313:2001石油和石油产品的试验方法.BS 2000-313-2001液压油和润滑油的释气值测定