DIN EN 583-6-2009 无损检验 超声波检验 第6部分:不连续性的探测和定尺寸用飞行时间衍射技术方法
Non-destructive testing - Ultrasonic examination - Part 6: Time-of-flight diffraction technique as a method for detection and sizing of discontinuities; English version of DIN EN 583-6:2009-03
This European Standard defines the general principles for the application of the Time-Of-Flight Diffraction
(TOFD) technique for both detection and sizing of discontinuities in low alloyed carbon steel components. It
could also be used for other types of materials, provided the application of the TOFD technique is performed
with necessary consideration of geometry, acoustical properties of the materials and the sensitivity of the
examination.
Although it is applicable, in general terms, to discontinuities in materials and applications covered by
EN 583-1, it contains references to the application on welds. This approach has been chosen for reasons of
clarity as to the ultrasonic probe positions and directions of scanning.
Unless otherwise specified in the referencing documents, the minimum requirements of this standard are
applicable.
Unless explicitly stated otherwise, this standard is applicable to the following product classes as defined in
EN 583-2:
-- class 1, without restrictions;
-- classes 2 and 3, restrictions will apply as stated in Clause 9.
The inspection of products of classes 4 and 5 will require special procedures. These are addressed in
Clause 9 as well.
The techniques to use TOFD for weld inspection are described in CEN/TS 14751.
The related acceptance criteria are given in prEN 15617.